River sand drying equipment is a common drying equipment, because the value of river sand drying equipment is reflected in many industries, it can realize the drying of large quantities of materials, reliable operation, simple operation, large flexibility, and adaptability. It is relatively high and widely used in various industries. However, there are a few things that need to be paid attention to when using it. Let's have a brief understanding with the river sand dryer manufacturer!

  1. Carry out the equipment idling test machine for no less than 4 hours after installation, and deal with the abnormal situation in time.

  2. After the idling test machine is finished, tighten and reinforce all the bolts again, check and make up the lubricating oil. The recheck test machine can be carried out without exception.

  3. Load test machine for empty test machine of all auxiliary equipment, and joint test machine if there is no abnormality.

  4. Ignite the hot air oven to preheat the dryer and use it with the dryer. It is forbidden to heat the cylinder without turning to prevent deformation and bending.

  5. According to the preheating situation, gradually add wet materials into the drying cylinder. Gradually increase the amount of feed. The preheating of the equipment requires a process, and the violent fire is prohibited. Prevent local overheating, uneven expansion, bending deformation, and damage to the equipment.

  6. The difference in fuel, the quality of insulation of each part, the difference in moisture content of wet materials, and the uniformity of feeding will all affect the quality of the dried products.

  7. When working, the frame of the tug must be filled with cooling water, and the lubrication parts should be refueled in time.

  8. Turn off the hot blast stove when parking, and the drying cylinder will continue to rotate until it cools down. It is forbidden to stop at high temperature to prevent bending and deformation from damaging the equipment.

  9. If there is a sudden power failure, the air heater should be turned off immediately and the feeding should be stopped. Rotate the cylinder half a turn for 15 minutes until it cools down. You must be responsible for this operation, otherwise it will cause the barrel to bend, seriously damage the equipment, and fail to operate normally.

  Zhengzhou Jiutian is a professional manufacturer of sand dryers, if you are interested, please feel free to contact us.